| Step | | Procedure & Parts & Tools |
| 1 |
|
Locate Drain Hoses at back of machine
|
| 2 |
|
Open caps and empty into floor sink or floor drain
|
| 3 |
|
step down on pedal and ensure it locks in the up position
|
| 4 |
|
Remove the 13mm bolt, located on the right side of machine.
| Ratchet-Socket metric 13mm |
|
|
| 5 |
|
LIFT THE TANK TO OPEN THE MACHINE
|
| 6 |
|
REMOVE THE 2 BOLTS FROM THE BRUSH DECK CASTER
| Wrench-Allen metric 5.0mm |
|
|
| 7 |
|
REMOVE THE REMAINING 5MM ALLEN HEADS AROUND THE BRUSH SHROUD.
|
| 8 |
|
LIFT THE SHROUND OFF
|
| 9 |
|
CHECK UNDER DECK. MAKE SURE IT IS PUSHED BACK COMPLETELY ON THE SHAFT AND MAKE SURE THIS COTTER PIN IS STILL IN PLACE.
|
| 10 |
|
VISUALLY INSPECT THE LINKAGE TO SEE IF ITS BENT OR BROKEN. MAKE SURE HARDWARE IS NOT MISSING AND TIGHT.
|
| 12 |
|
IF THE LINKAGE IS OKAY, REPLACE THE BRUSH HEAD SHROUD, CLOSE THE TANK AND REPLACE THE TANK BOLT. FILL THE SOLUTION TANK IF NEEDED
|